PICmicro® studio - intermediate projects

One Rx input circuit

Code: 601 Name: spser

With this module you can control two RS232 devices with a single port of your PC. You can set up commands in order to select the output: 1 or 2 at your choice. Discover the secrets of the serial communications.

Hardware: Board for PIC16F84, power supply, analogical switch, and RS232 drivers.

Software: Floppy disk containing data sheet and a complete PBP program. Does not include PBP compiler.

RS232 Trainer

Code: 602 Name: t232

Learn how to set up controls that communicate with a PC. Using the serial port of the PC you can send commands to read the state of contacts, or to turn on lights, relays, etc. Discover the secrets of the serial communications.

Hardware: Board for the PIC16F84, buttons, LEDS. Ready to use.

Software: Floppy disk containing several examples to begin in the PIC® microcontroller programming. Does not include PBP compiler.

RS485 Trainer

Code: 603 Name: trs485

Learn to make controls communicate themselves with a single pair of cables. With the RS485 hardware many micros can be interconnected to a single pair of cables. Discover the secrets of the multidroping serial communications.

Hardware: Board with an integrated source for RS485, and base for a PIC16F84.

Software: Floppy disk containing data sheet, several examples and internet addresses.

IR Proximity Sensor 1 CMOS/TTL Output

Code: 607 Name: spre1

Software: Schematics diagram and software.

This module is able to detect objects and people from distances ranging aproximately a few centimeters to 1 meter. The module comes with a pair of leds and an IR sensor. Using the potenciometers you change the lighten level of the IR leds, then adjusting the resulting area detection. A PIC12C508 controls the IR leds and receives the sensor signal. One pin is used for output. Every detection turns on the output (1 logic).

Hardware: PIC12C508 Power Supply: 5V DC.

IR Proximity Sensor 1 rele Output

Code: 608 Name: spreir

Software: Schematic Diagram and sofware.

This module is able to detect objects and people from distances ranging aproximately a few centimeters to 1 meter. The module comes with a pair of leds and an IR sensor. Using the potenciometers you change the lighten level of the IR leds, then adjusting the resulting area detection.

One PIC12C508 controls the IR leds and receives the sensor signal. Using a ULN2003A circuit, every detection goes through one PIC's pin and turns on the rele.

Hardware: PIC12C508 Power Supply: 5V CD.